Gateway 210 ユーザーガイド
35
Maintaining the projector
www.gateway.com
Maintaining the projector
The only user-replaceable part in the projector is the lamp module. Contact
Gateway Technical Support for any additional service or repair.
Gateway Technical Support for any additional service or repair.
Changing the lamp module
You should replace the lamp module in the projector every 1500 hours to
maintain the best possible display image. Do not use a lamp module past the
rated lamp life.
maintain the best possible display image. Do not use a lamp module past the
rated lamp life.
To replace the lamp module:
1
Turn off the projector and wait for the fan to stop.
2
Disconnect the power cord and all other external cables.
3
Let the projector lamp cool completely (approximately 30 minutes).
4
Turn the projector over so the bottom is facing up.
Warning
To prevent electric shock, do not open the projector case.
There are no user-replaceable parts inside. Contact
Gateway Technical Support for service or repair.
There are no user-replaceable parts inside. Contact
Gateway Technical Support for service or repair.
Warning
The high-pressure lamp module may explode if handled
incorrectly. Make sure that the projector is turned off, power
is disconnected, and the lamp is completely cool (minimum
of 30 minutes) before replacing the lamp module.
incorrectly. Make sure that the projector is turned off, power
is disconnected, and the lamp is completely cool (minimum
of 30 minutes) before replacing the lamp module.