Gateway dx4200 参照ガイド

www.gateway.com

43

Adding or replacing an optical 
disc drive

To add replace an optical drive:

 

1

Remove the front bezel by following the instructions in 

.

2

If you are installing a new drive (not replacing an old 
one), remove the two drive retention screws in the drive 
bay, then go to 

Step 7

. For the location of the screws, see 

the photo in 

Step 5

3

If you are replacing an existing drive, disconnect the 
cables from the drive, noting their locations and 
orientation. You will reconnect the cables after you 
install the new drive. 

4

Note any jumper settings on the old drive and set the 
jumper on the new drive to be the same.

You need a Phillips screwdriver to add or replace an optical drive.

The color and shape of your replacement drive’s front cover may 

vary from your original drive.

Drive data cable

Drive power cable