Heartland 9730 ユーザーガイド

1.

Lift the unit up to the opening and guide the supply box through the slot into the lower cupboard
at the back of the opening. The power supply box and cable must be fully inserted into the lower
cupboard or the appliance will not install completely into the enclosure.

2.

Slide the unit into place and check that the unit is level by placing a spirit level across the top
of appliance front. If levelling is required, shim the unit between the base and the bottom opening.

3.

After unit has been levelled, secure the unit to the cupboard with two screws along the top, into
the two anchor clips installed previously. (see below and page 5 illustration  )

4.

Remove cover of the power supply box and fasten the supply box to the back of the cupboard

below with four wood screws (See page 5).

5.

The unit can now be wired into the power source by a qualified electrician.

6.

Before turning the unit on please read “Before you Start” under the Operation section on page
10.

Note:
The oven face should not go inside the opening. Following these directions the face-plate will
over lap the cabinet by 1/4" top and bottom and on the sides. The flange will extend 1 1/2" off
the face of the cabinet when mounted.

Anchor clips

Screw unit to anchor clips
installed in cabinet opening