KYOCERA KM-4230 ユーザーガイド
Using the Scan Functions
8
8-51
8.8.3
Setting the Proxy Server
When using a proxy server, you must enter settings using Printer
Management Utility.
Management Utility.
✎
Note
To use a proxy server, set “Use Proxy” to “Yes” when registering the
FTP server using Printer Management Utility. (Refer to “Registering
FTP Servers” on page 8-48.)
To use a proxy server, set “Use Proxy” to “Yes” when registering the
FTP server using Printer Management Utility. (Refer to “Registering
FTP Servers” on page 8-48.)
Setup procedure
1
Start up Printer Management Utility.
2
Enter the administrator access code, and log in to Administrator mode.
3
On the “Network” tab, click
FTP Server
, and then click
FTP
Configuration
in the sub-menu that appeared.
4
Specify settings for the following.
Proxy IP Address
Enter the IP address of the proxy server when a proxy server
is used.
is used.
Port Number
Set the port number of the proxy server.
(Normally, use the default value of 21.)
(Normally, use the default value of 21.)
FTP Connection Timeout
Set the connection timeout for the FTP server.
Passive Mode
Set the passive mode.