Juniper 1-Port SFP Mini-PIM SRX-MP-1SFP ユーザーズマニュアル
製品コード
SRX-MP-1SFP
Using the Point and Click CLI to Set Interface Mode and Speed Options
To set the interface mode and speed options for the 2-Port 10 Gigabit Ethernet XPIM
with the Point and Click CLI:
with the Point and Click CLI:
1.
From the J-Web interface main menu, select Configure>CLI Tools>CLI Tools>Point
and Click CLI.
and Click CLI.
2.
Next to Interfaces, click Configure or Edit. The Interfaces page displays.
3.
Click the Interface name or click Edit. The details page for the specified interface
appears.
appears.
4.
To set the mode for the 2-Port 10 Gigabit Ethernet XPIM, select either fiber or copper
from the Mode drop-down list box.
from the Mode drop-down list box.
NOTE:
By default, interfaces run in fiber mode at 10 G speed with
autonegotiation.
5.
To set the speed for the 2-Port 10 Gigabit Ethernet XPIM, select 10m, 100m, 1g, or 10g,
from the Speed drop-down list box.
from the Speed drop-down list box.
NOTE:
For copper ports, all 10 Mbps, 100 Mbps, 1 G, and 10 G speeds are
supported; for fiber ports, only 1 G and 10 G speeds are supported.
6.
Click OK to save changes, and click Commit to apply the configuration and other
pending changes (if any).
pending changes (if any).
For advanced configuration information, see the
.
Using the CLI
To perform basic configuration for the 2-Port 10 Gigabit Ethernet XPIM and to configure
network interfaces for the services gateway with the CLI:
network interfaces for the services gateway with the CLI:
•
Verify that the 2-Port 10 Gigabit Ethernet XPIM is installed on the services gateway:
show chassis hardware
•
Verify the FPC status of the interface:
show chassis fpc
•
Assign the port an IP address:
set interfaces xe-6/0/0 unit 0 family inet address interface address/destination prefix
117
Copyright © 2012, Juniper Networks, Inc.
Chapter 12: 2-Port 10 Gigabit Ethernet XPIM