Viewsonic NMP-570w ユーザーズマニュアル

3

2.1. System connections

1.    Attach a video cable (either VGA or HDMI) to your monitor. 

When using the 

VGA connection, your monitor should support XGA 

(1024x768) resolution or greater. For audio output, you will also need 

to connect a stereo RCA cable from the NMP-570/NMP-570w to your 

monitor.  
When using an 

HDMI connection, audio is sent along with video over the 

HDMI cable, so no additional cables are required.
Reminder:   If you do not see anything on screen, check your monitor 

video input mode.

2.    Attach the AC power adapter to power on the unit. Shortly afterwards, the 

following progress bar will be displayed on your monitor:

3.   Player boot process takes approximately 90 seconds to complete. The 

player will indicate that it is ready for content sync via the USB port or, if 

content has been loaded, begin playback immediately.

After performing the initial setup as 

outlined above, the player will boot 

into the “Open Standard Media Player” 

screen.  Plug in a USB keyboard to 

enter configuration menus. 
If you have already loaded media 

contents into the player, contents will 

 

90 seconds