Viewsonic CDP4260-TL ユーザーズマニュアル

8

The remote control is powered by two 1.5V AAA 
batteries.
To install or replace batteries: 
1.  Press and then slide the cover to open it. 
2.  Align the batteries according to the (+) and (–) 

indications inside the battery compartment. 

3.  Replace the cover. 

 

The incorrect use of batteries can result in leaks or 
bursting. Be sure to follow these instructions: 
•  Place “AAA” batteries matching the (+) and (–) 

signs on each battery to the (+) and (–) signs of 
the battery compartment.

•  Do not mix battery types.
•  Do not combine new batteries with used ones. 

It causes shorter life or leakage of batteries.

•  Remove the dead batteries immediately to 

prevent them from liquid leaking in the battery 
compartment. Don’t touch exposed battery acid, 
as it can damage your skin.

NOTE: If you do not intend to use the remote 

control for a long period, remove the 
batteries.

2.3.3.  Handling the remote control
•  Do not subject to strong shock.
•  Do not allow water or other liquid to splash the 

remote control. If the remote control gets wet, 
wipe it dry immediately.

•  Avoid exposure to heat and steam.
•  Other than to install the batteries, do not open 

the remote control.

2.3.4.  Operating range of the remote control
Point the top of the remote control toward the 
display’s remote control sensor when pressing a 
button.
Use the remote control within a distance of less 
than 10m/33ft from the display’s sensor, and 
a horizontal and vertical angle of less than 30 
degrees.

NOTE: The remote control may not function 

properly when the remote control sensor on 
the display is under direct sunlight or strong 
illumination, or when there is an obstacle in 
the path of signal transmission.

30

30