Viewsonic SD-Z246 ユーザーズマニュアル

7

Use the buttons on the front control panel to display and adjust the OSD controls 

which display on the screen.

Standby Power On/Off

MENU/EXIT

Displays the Main Menu or exits the control screen and saves adjustments.

SOURCE/ENTER

Displays the control screen for the highlighted control.

Also a shortcut to toggle analog and PCoIP.

Scrolls through menu options and adjusts the displayed control.

Blue light filter (▼) / ViewMode (▲)

Power indicator

Blue = ON

Orange = Power Saving
PCoIP indicator

Green = PCoIP activate

Orange = Standby

Blank = PCoIP OFF
Link indicator

Blue = When the Client is connected.

Activate the PCoIP when the Client is connected.

*  PCoIP: PC over IP is a display protocol that allows complete compression of a 

desktop displayed through a zero client device over standard IP network.

1.  To display the Main Menu, press button [1].

NOTE: All OSD menus and adjustment screens disappear automatically after 

about 15 seconds. This is adjustable through the OSD timeout setting in the 

setup menu.

2.  To select a control to adjust, press ▲ or ▼ to scroll up or down in the Main 

Menu.

3.  After the desired control is selected, press button [2].
4.  To save the adjustments and exit the menu, press button [1] until OSD 

disappear.

•  Adjust the computer’s graphics card to support a recommended timing mode 

(refer to “Specifications” page for recommended setting specific to your Zero 

Client Monitor). To find instructions on “changing the refresh rate”, please refer to 

the graphics card’s user guide.

•  If necessary, make small adjustments using H. POSITION and V. POSITION 

until the screen image is completely visible. (The black border around the edge 

of the screen should barely touch the illuminated “active area” of the Zero Client 

Monitor.)