Sony SDM-V72W マニュアル
- 9 -
Activating and replacing a battery for remote card
Activating the remote card
To activate the battery for the remote card,
remove the plastic slip by pulling the tab.
remove the plastic slip by pulling the tab.
Replacing the remote card battery
1
To replace the worn battery with a new
one, remove the battery compartment
from the remote card by pressing the
lock latch to the right, then pull out the
compartment.
one, remove the battery compartment
from the remote card by pressing the
lock latch to the right, then pull out the
compartment.
2
Be sure that the positive terminal (+) of
the CR2025 lithium battery is facing
upward.
the CR2025 lithium battery is facing
upward.
3
Close the battery compartment to with a
gentle push until you hear the click.
gentle push until you hear the click.
The worn battery should be disposed
properly. Check with your local regulations.
properly. Check with your local regulations.
Setup 1
1
2
z
Handle the remote card with care. Do
not try to bend it, drop it or get it wet. Avoid
placing it near a heater, in direct sunlight, or
where humidity is high.
placing it near a heater, in direct sunlight, or
where humidity is high.
✍
Caution:
Keep the batteries away from the
reach of young children. Batteries may pose
a potential health hazard if put in their
mouth (i.e., they may swallow it or choke on
it).
a potential health hazard if put in their
mouth (i.e., they may swallow it or choke on
it).