KitchenAid Custom Pour Over Brewer 使用とお手入れ

After pressing SET to choose AM or PM 

for your Delay start brew time, 2 beeps 

will sound and you will be returned to 

the programming menu.  The Delay start 

program is ready to use.

The water tank holds between 2 and 8 cups 

of water (5 oz. each) for brewing. Since you 

are able to select the number of cups you’d 

like to brew each time, you do not have to 

fill the water tank with the exact amount of 

water you need. The Coffee Maker will use 

the correct amount of water for the number 

of cups you select.

Slide the water tank lid back, and fill  

the water tank with fresh, filtered water 

to the desired cup level as indicated on 

the water tank view. Because of the 

design of this Coffee Brewer, it may take 

a moment for the water to enter the 

place in the tank where you can view the 

water level. Close the water tank lid.

You can use the same Delay start brew time 

again by pressing the menu button twice, then 

pressing SET three times before brewing. To 

cancel the Delay start feature at any time, 

press the BREW button two times.

NOTE: You must complete step 4 each time you wish to enable the Delay start feature.

NOTE: If the water in the tank has been sitting for awhile and you wish to start fresh, 

select 8 cups and press the BREW button (without coffee in the brew basket). This will 

cycle through any stale water in the tank.

HELPFUL TIP: For best taste and brewing results, make sure you have enough water in 

the tank for the number of cups you want to brew.

W10661890A_EN_Final2.indd   11

7/2/14   9:48 AM