KitchenAid kdrs407vss 寸法図

ページ / 2
PRODUCT MODEL NUMBERS
Because Whirlpool Corporation includes a continuous commitment to improve our 
products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation 
Instructions packed with product. Specifications subject to change without notice.
Page 1 of 2
Ref. W10896182A
09/21/2016
KDRU767V
KDRU783V
KDRS483V
KDRU763V
KDRS407V
KDRS463V
KDRS467V
30" (76.2 cm), 36" (91.4 cm), and 48" (121.9 cm) 
Commercial-Style Dual Fuel Convection Ranges
ELECTRICAL CONNECTION
To properly install your range, you must determine the type of electrical 
connection you will be using and follow the instructions provided for it 
here.
 
Range must be connected to the proper electrical voltage and 
frequency as specified on the model/serial/rating plate. The model/
serial/rating plate is located on the right vertical surface of the oven 
door frame. Refer to the illustrations in “Product Dimensions” of the 
“Location Requirements” section.
 
This range may be manufactured with a 4-wire power supply cord or 
may not include a power supply cord. If your range does not include a 
power supply cord, use a 4-wire power supply cord rated at 250 volts, 
40 or 50 amps, and investigated for use with ranges
Range Rating*
Specified Rating of Power 
Supply Cord Kit and Circuit 
Protection
120/240 Volts
120/208 Volts
Amps
Range Size
8.8–16.5 kW
7.8–12.5 kW
40 or 50**
30" (76.2 cm) 
36" (91.4 cm)
16.6–22.5 kW
12.6–18.5 kW
50
48" (121.9 cm)
  * The NEC calculated load is less than the total connected load listed 
on the model/serial/rating plate.
 ** If connecting to a 50-amp circuit, use a 50-amp rated cord with kit. 
For 50-amp rated cord kits, use kits that specify use with a nominal 
13/8" (34.9 mm) diameter connection opening.
 
A circuit breaker is recommended.
 
Wire sizes and connections must conform with the rating of the range.
 
The Tech Sheet is located behind the kick plate in a clear plastic bag.
TYPE OF GAS
Natural Gas:
This range is factory set for use with Natural gas. The model/serial/
rating plate located on the right vertical surface of the oven door frame 
has information on the types of gas that can be used. If the types of gas 
listed do not include the type of gas available, check with the local gas 
supplier.
LP Gas Conversion:
Conversion must be done by a qualified service technician.
No attempt shall be made to convert the range cooktop from the gas 
specified on the model/serial/rating plate for use with a different gas 
without consulting the serving gas supplier. To convert to LP gas, use 
the LP gas conversion kit provided with your range and see the “Gas 
Conversions” section. The parts for this kit are in the literature package 
supplied with the range.
GAS SUPPLY LINE
 
Provide a gas supply line of 
3
/
4
” (1.9 cm) rigid pipe to the range 
location. A smaller size pipe on longer runs may result in insufficient 
gas supply. With LP gas, piping or tubing size can be 
1
/
2
” (1.3 cm) 
minimum. Usually, LP gas suppliers determine the size and materials 
used in the system.
NOTE: Pipe-joint compounds that resist the action of LP gas must be 
used. Do not use TEFLON
®†
 tape.
Flexible metal appliance connector:
 
If local codes permit, a new CSA design-certified, 4-5 ft (122-
152.4 cm) long, 
5
/
8
" (1.6 cm) or 
3
/
4
" (1.9 cm) I.D. flexible metal 
appliance connector may be used for connecting range to the gas 
supply line.
 
1
/
2
" (1.3 cm) male pipe thread is needed for connection to the 
female pipe threads of the inlet to the range pressure regulator.
 
Do not kink or damage the flexible metal tubing when moving the 
range.
IMPORTANT: All connections must be wrench-tightened. Do not make 
connections to the gas regulator too tight. Making the connections too 
tight may crack the regulator and cause a gas leak. Do not allow the 
regulator to turn or move when tightening fittings.
 
Must include a shut-off valve:
The supply line must be equipped with a manual shut-off valve. This 
valve should be located in the same room but external to the range 
opening such as an adjacent cabinet. It should be in a location that 
allows ease of opening and closing. Do not block access to shut-off 
valve. The valve is for turning on or shutting off gas to the range.
A
B
C
A.  Gas supply line
B.  Shut-off valve “open” position
C.  To range
®
TEFLON is a registered trademark of Chemours.
30" (76.2 cm) models
D
C
A
B
E
A.  Optional backguard may be installed.
B. 27
3
/
4
" (70.5 cm) depth with control panel (See NOTE)
C. 35
3
/
4
" (90.8 cm) cooktop height when sitting on the wheels
D.  30" (76.2 cm) width
E.  Model/serial/rating plate location
PRODUCT DIMENSIONS