KitchenAid 30-Inch 4 Burner Gas Cooktop, Architect® Series II インストールガイド

Tighten screws just enough to hold brackets in place when 

cooktop is put in cutout.

Using 2 or more people, turn the cooktop right side up and 

place in cutout.
NOTE: 

Make sure that the front edge of the cooktop is 

parallel to the front edge of the countertop. If repositioning is 

needed, lift entire cooktop up from cutout to avoid scratching 

the countertop.

Loosen the screws and rotate the brackets so that they are 

perpendicular to the edge of the cooktop base and extend 

beyond its edge. Securely tighten screws.

Using 2 or more people, place cooktop right side up into the 

cutout.
NOTE: 

Make sure that the front edge of the cooktop is 

parallel to the front edge of the countertop. If repositioning is 

needed, lift entire cooktop up from cutout to avoid scratching 

the countertop.

Remove the attachment screws for the selected bracket 

locations from the bottom of the cooktop base. 

Select bracket mounting holes that will allow the bracket to 

extend far enough out from the cooktop for the installation of 

2½" (6.4 cm) clamping screws.

Attach brackets to cooktop base bottom with bracket 

attachment screws using the bracket mounting holes 

selected in Step 3. Securely tighten screws.

Using 2 or more people, stand the cooktop on its side or 

back.

Connect the flexible stainless steel connector to the pressure 

regulator using a ½" male pipe thread adapter and nipple.
A combination of pipe fittings must be used to connect the 

cooktop to the existing gas line. Shown following is a typical 

connection. Your connection may be different, according to 

the supply line type, size and location.

Install the pressure regulator with the arrow pointing up 

toward the bottom of the cooktop base and in a position 

where you can reach the regulator cap.

 All connections must be wrench-tightened. Do 

not make connections to the gas regulator too tight. Making 

the connections too tight may crack the regulator and cause 

a gas leak. Do not allow the regulator to turn on the pipe 

when tightening fittings.

Use only pipe-joint compound made for use with Natural and LP 

gas. 
Do not use TEFLON

®

 tape. You will need to determine the fittings 

required depending on your installation.

A

B

C

D

E

F

G

A

B

C

D