Nikon WT-3A (D200) ユーザーズマニュアル
20
3
Insert the battery as shown on the inside of the
battery chamber cover. The battery latch will slide
aside during insertion and pop up to lock the bat-
tery in place when fully inserted.
battery chamber cover. The battery latch will slide
aside during insertion and pop up to lock the bat-
tery in place when fully inserted.
Inserting the Battery
To power the camera when the WT-3 is in place, insert the camera battery into the
WT-3 battery chamber. The WT-3 takes one EN-EL3e rechargeable Li-ion battery;
other batteries can not be used. Note that the drain on the battery is increased
when the WT-3 is attached.
To power the camera when the WT-3 is in place, insert the camera battery into the
WT-3 battery chamber. The WT-3 takes one EN-EL3e rechargeable Li-ion battery;
other batteries can not be used. Note that the drain on the battery is increased
when the WT-3 is attached.
The EH-6 AC Adapter
The optional EH-6 AC adapter can also be used to power the
camera when the WT-3 is connected. Connect the DC plug
on the AC adapter to the WT-3 DC-IN connector, not to the
camera.
camera when the WT-3 is connected. Connect the DC plug
on the AC adapter to the WT-3 DC-IN connector, not to the
camera.
2
Open the battery chamber cover.
4
Close the battery-chamber cover. Make sure the
cover is properly latched. The latch will click into
place when the cover is fully closed.
cover is properly latched. The latch will click into
place when the cover is fully closed.
5
Turn the camera on and check the battery level in
the control panel or viewfi nder or using the Bat-
tery Info option in the camera setup menu.
tery Info option in the camera setup menu.
1
Turn the camera off and rotate the control lock on
the WT-3 to the L position.
the WT-3 to the L position.
Removing the Battery
Being careful not to drop the battery, open the battery cham-
ber cover and remove the battery as shown at right.
ber cover and remove the battery as shown at right.
Batery latch