Canon REALiS WUX10 Mark II D ユーザーズマニュアル
Selecting an Input Signal (INPUT)
50
■Selecting an Input Signal
1
Press the INPUT button to pop up a window shown at the lower right.
The currently active input signal is marked with a circle and highlighted in orange.
An input signal that is ready for projection is displayed in white. When no signal is
received, it is displayed in gray. [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be
displayed in gray even if they are ready for projection.
An input signal that is ready for projection is displayed in white. When no signal is
received, it is displayed in gray. [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be
displayed in gray even if they are ready for projection.
2
The selection is toggled through available input signal types by pressing the INPUT
button.
button.
• You can select the target input signal with [ ] / [ ].
• Only the input signals displayed in white can be selected.
• Only the input signals displayed in white can be selected.
3
Press the OK button to determine the input signal type.
If no button is pressed in 4 seconds, the selected input signal type is chosen.
If no button is pressed in 4 seconds, the selected input signal type is chosen.
Remote control
Top control
<
<