Canon XF100 マニュアル

Recording Video

2 Press the START/STOP button to begin recording.

• Recording starts. The front and rear tally lamps illuminate and the

recording indicator [NREC] appears on the screen.

• You can use the START/STOP button on the side grip or handle.

• When you use the wireless controller, press the START/STOP button

and the record enable button simultaneously.

3 Press the START/STOP button to pause the recording.

• The clip* is recorded to the CF card and the camcorder enters record

pause mode. The tally lamps will also go out.

* “Clip” refers to one movie unit from the point you press the START/STOP button to start

recording until you press again to pause the recording. You can also include custom
picture settings (0 100) and metadata (0 83) with the clip.

IMPORTANT

• Observe the following precautions while the CFj or CFl access

indicator is illuminated in red. Failure to do so may result in permanent
data loss.
- Do not open the CF card slot cover of the CF card slot being accessed and remove the CF card.
- Do not disconnect the power source or turn off the camcorder.

• Be sure to save your recordings regularly (0 132), especially after making important recordings. Canon shall

not be liable for any loss or corruption of data.

NOTES

• The START/STOP button on the handle has a lock lever to prevent accidental operation. Set the lock lever to

R in cases such as when you do not want a recording inadvertently paused or do not plan to use the START/
STOP button. Return the lever to its previous position to enable use of the START/STOP button again.

• You can use the [J Other Functions]

[Rec Review] setting (0 88) to review the last clip recorded.

• If you set an assignable button to [Add e Mark] or [Add Z Mark] (0 98), you can press the button to add an

e mark or Z mark to the last clip recorded.

• You can use the [J Other Functions]

[Clips]

[Delete Last Clip] setting (0 151) to delete the last clip

recorded. Alternatively, you can set an assignable button to [Delete Last Clip]. However, you cannot delete the
last clip if double slot recording is on.

• b When you set the [J Other Functions]

[SDI Rec Command] setting to [On] and you connect the

camcorder to another device using the HD/SD SDI terminal, if you start or stop recording with the camcorder,
the other device will also start or stop recording. For more details, visit your local Canon Web site.

• The area around the tripod base may become hot after using the camcorder for an extended period of time.

This is not a malfunction.

COP