ASUS RS700-E7/RS8 ユーザーズマニュアル

5-22

Chapter 5: BIOS setup

5.4.4

PCH SATA Configuration

(1)IDE Mode. (2)AHCI Mode.

(3)RAID Mode.

SATA Port1

Not Present

SATA Port2

ASUS DWR ATAPI

SATA Port3

WDC WD800JD(80.0GB)

SATA Port4

Not Present

SATA Port5

Not Present

SATA Port6

Not Present

SATA Mode

[IDE Mode]

Serial-ATA Controller 0

[Enhanced]

Serial-ATA Controller 1

[Enhanced]

S.M.A.R.T. Status Check [Enabled]

→←:

Select Screen

↑↓:

Select Item

Enter: Select Item

+/-: Change Opt.

F1: General Help

F2: Previous Values

F5: Optimized Defaults

F10: Save & Exit

ESC: Exit

SATA Mode [IDE Mode]

Allows you to set the SATA configuration.

Configuration options: [Disabled] [IDE Mode] [AHCI Mode] [RAID Mode]

• If you want to use the Serial ATA hard disk drives as Parallel ATA physical

storage devices, keep the default setting [IDE Mode].

• If you want the Serial ATA hard disk drives to use the Advanced Host

Controller Interface (AHCI), set this item to [AHCI Mode]. The AHCI allows

the onboard storage driver to enable advanced Serial ATA features that

increases storage performance on random workloads by allowing the drive

to internally optimize the order of commands.

• If you want to create RAID sets with LSI MegaRAID utility, or Intel

Rapid

Storage Technology Enterprise from the Serial ATA hard disk drives, set this

item to [RAID Mode].

Advanced

Serial-ATA Controller 0 [Enhanced]

This item appears only when you set the SATA Mode item to [IDE Mode]. Set to

[Enhanced] to support two SATA 6.0 Gb/s and two SATA 3.0 Gb/s devices. Set to

[Compatible] when using Windows 98/NT/2000/MS-DOS. Up to four SATA devices

are supported under these operating systems.

Configuration options: [Disabled] [Enhanced] [Compatible]

Serial-ATA Controller 1 [Enhanced]

This item appears only when you set the SATA Mode item to [IDE Mode]. Set

to [Enhanced] to support two SATA 3.0 Gb/s devices. Configuration options:

[Disabled] [Enhanced]