ASUS P5N32-SLI Premium/WiFi-AP ユーザーズマニュアル

ASUS P5N32-SLI Premium

2-25

This connector is for the provided floppy disk drive (FDD) signal cable. Insert 

one end of the cable to this connector, then connect the other end to the 

signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when 

using a FDD cable with a covered Pin 5.

The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. 

There are three connectors on each Ultra DMA 133/100/66 signal cable: 

blue, black, and gray. Connect the blue connector to the motherboard’s IDE 

connector, then select one of the following modes to configure your device.

•  Pin 20 on the IDE connector is removed to match the covered hole on the 

Ultra DMA cable connector. This prevents incorrect insertion when you 

connect the IDE cable.

•  Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select,” make sure all other device 

jumpers have the same setting.

Single device

Cable-Select or Master

-

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Master

Black or gray

Slave

Slave

®

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

PIN 1

FLOPPY