Canon XU-81W マニュアル

E15

3.  Checks after Completion of Connection

3-1. At the Unit Installation Site

Refer to the figure of “2. Connections” and check if all the cables are 

properly connected.

3-2.  At the Control Site

When OP-300 is used

To start operation

①  Press the POWER switch of the 

operation unit.

  (Check → The green LED lights.)

②  The TAKE switch lights up, and a head  

response is awaited.

  (Check → The TIME display LED 

indicates  

.)

The system waits for a response from the pan-tilt head. After a few seconds when 

communication with the pan-tilt head is established, the shot movement time is 

displayed (example: 11 s = 

) and the other switches are enabled.

To end operation

①  Press to turn off the POWER switch of the operation unit.

 

(Check → The green LED goes off.)

The operating procedures vary depending on the operation unit that is used. 

Please refer to the operation manual of your operation unit.

TAKE switch

POWER switch

TIME display LED