Canon imagePROGRAF iPF9400S マニュアル

4

• Remove the tape on the pieces to prevent 

slippage by pulling the tape across the 

pieces from above when peeling off.

Caution

MEMO

MEMO

a

a

b

a

a

d

b

b

c

e

e

• Do not cut the black belts around the printer 

until step 11. When the black belts are cut, 

Tipping installation is no longer possible.

Remove the bottom cardboard sheet and 

the pallet. Assemble the cardboard stand 

holder as shown and put the holder to 

the bottom side of the printer. Let the 

side with round holes (a) face the printer.

Use scissors to cut openings in the plastic 

covering as shown. Pull the covering apart 

with both hands to expose the sections of the 

printer where the  Stand    will be attached.

Bend the front flap of the cardboard stand 

holder forward as shown. Collapse the 

holder and remove the holder from under 

the stand.

Place the bottom sheet (a) under the 

printer. Have four people hold the printer 

and Stand on both ends, two people on 

each end. As you support the printer, tip 

it forward, pivoting it on the pieces of the 

Stand to prevent it from slipping (b).

Remove the black belts (a) from the 

printer. 

Rest the  Stand    on its side on the 

cardboard stand holder. Adjusting the 

positions for attachment to the printer, 

use an Allen Wrench to tighten four M4 

screws on both sides, attaching the stand 

securely to the printer.

Remove the packaging material and the 

plastic covering from the other side of the 

printer the same way.

• Be careful to prevent the  Stand    from slipping.

Remove the black belts from around the 

printer and remove the top packaging 

material.

While two people hold the carrying handles 

under the printer on one end and lift the 

printer a little, have a third person remove the 

packaging material and the plastic covering 

from under the printer. After the packaging 

material has been removed, lower the printer.

• To avoid scratching the floor, be sure to 

place the bottom sheet on the floor.

Remove the packaging material (b), the 

box (c) with the  Rewind Spool    inside, the 

plastic covering (d), and the pieces (e) 

attached to casters to prevent slippage.

• When cutting the black belts, be careful not 

to let the belts fly away from the printer.

Lifting installation: In the case of installation by six people

Remove the packaging material covering 

the sections of the printer where the 

Stand will be attached.

Remove the Sample Paper.

Turn the joints to pull out of the bottom 

cardboard sheet on top of the pallet, and 

then remove the cardboard stand holder.