Olympus P-11 取り扱いマニュアル

ページ / 164
31
ENGLISH
Preparation
P
rinting
For Your 
Reference
Introduction
Troubleshooting
Before sending your printer for service, check the following to try to resolve the 
problem. If the problem persists, contact your nearest Olympus service center.
• If paper is jammed, see page 32. “If paper is jammed”
Problem
Cause·status
Resolution
Page
Cannot turn the 
printer on.
The AC adapter is not 
connected.
Connect the AC adapter 
properly.
14
Cannot remove 
the ink ribbon 
cartridge.
The printer turned off 
during the operation.
Push the ink ribbon cartridge in 
until 
you hear a clicking 
sound.
 Turn the printer on 
again and wait until the 
mechanical sound stops.
Printing from the 
digital camera 
takes a long time 
to start.
The printer takes a long 
time to open a TIFF file.
Opening time varies depending 
on the image size. Wait until 
opening finishes.
Trimming selected by 
DPOF takes a long time.
Wait until opening finishes.
Printing does not 
start.
The paper or ribbon 
cartridge is not suitable 
for the paper size you are 
using.
Use the same size ribbon 
cartridge and paper.
18, 35
The print size set on the 
digital camera or computer 
does not match the sizes 
of the loaded paper and 
ribbon cartridge.
Insert the same size paper and 
ribbon cartridge as selected on 
the digital camera or computer.
The ink ribbon cartridge is 
not Inserted.
Insert an ink ribbon cartridge.
16
Paper or the paper tray is 
not inserted.
Load paper into the paper tray 
and then insert the paper tray.
20, 22
Paper is jammed at the 
paper eject section.
Remove the paper.
32
The printer driver is not 
properly installed on the 
computer.
Install or re-install the printer 
driver on the computer.
26
Indicators light or blink.
30
Noise interferes 
with printed 
images.
Pictures that were not 
taken with a digital 
camera were printed from 
a digital camera.
Use a computer to print image 
data that has not been 
recorded by a digital camera.
26
Printing intervals 
have become 
longer.
Printing intervals are 
automatically extended 
during continuous printing 
to prevent the internal 
components from 
overheating.
This is not a malfunction. Wait 
a few minutes.
p11_e_000_bookfile.book  Page 31  Monday, July 25, 2005  10:47 AM