Olympus e-3 入門マニュアル
75
EN
6
Flash shooting
Functions available with external flash units
* The focal length of the lens that can be used (Calculated based on 35 mm film camera)
x
Notes
• The FL-40 optional flash cannot be used.
Using the external electronic flash
Be sure to attach the flash to the camera before turning on the flash’s power.
1
Remove the hot shoe cover by sliding it
in the direction indicated by the arrow in
the illustration.
in the direction indicated by the arrow in
the illustration.
• Keep the shoe cover in a safe place to avoid
losing it, and put it back on the camera after
flash shooting.
flash shooting.
2
Attach the electronic flash to the hot
shoe on the camera.
shoe on the camera.
• If the lock pin is protruding, turn the shoe lock
ring as far as it will go in the direction opposite
to LOCK. This will pull the lock pin back
inside.
to LOCK. This will pull the lock pin back
inside.
3
Turn on the flash.
• When the charge lamp on the flash lights up,
charging is complete.
• The flash will be synchronized with the camera
at a speed of 1/250 sec. or less.
4
Select a flash mode.
5
Select the flash control mode.
• TTL-AUTO is recommended for normal use.
6
Press the shutter button halfway.
• Shooting information such as ISO sensitivity,
aperture value, and shutter speed is
communicated between the camera and flash.
communicated between the camera and flash.
7
Press the shutter button all the way.
x
Notes
• The built-in flash cannot be used when an
external flash is attached to the hot shoe.
Optional flash
FL-50R
FL-50
FL-36R
FL-36
FL-20
RF-11
TF-22
Flash control mode
TTL-AUTO, AUTO, MANUAL,
FP TTL AUTO, FP MANUAL
TTL-AUTO,
AUTO, MANUAL
TTL-AUTO,
MANUAL
GN (Guide
number)
(ISO100)
number)
(ISO100)
GN50 (85 mm
*
)
GN28 (24 mm
*
)
GN36 (85 mm
*
)
GN20 (24 mm
*
)
GN20 (35 mm
*
)
GN11
GN22
RC mode
9
k
9
k
k
k
k
Hot shoe cover
Lock pin
Lock ring
s0011_e_00_0_unified.book Page 75 Wednesday, September 12, 2007 4:46 PM