Olympus e-p1 入門マニュアル

ページ / 164
60
EN
3
Fo
cu
si
ng and
 shootin
g function
s
If the camera’s focus does not focus, the easiest solution is to use the focus lock. Use this 
when composing the subject outside of the AF targets or when the subject is difficult to focus 
on.
1
Adjust 1 selected AF target to the subject to be 
focused and press the shutter button halfway 
until the AF confirmation mark lights up. 
(Single target AF mode)
• The focus is locked. The AF confirmation mark and 
the AF target in focus light up on the LCD monitor.
• If the AF confirmation mark blinks, press the shutter 
button halfway again.
• The AF target mark is displayed for only a moment 
when the shutter button is pressed halfway.
2
While pressing the shutter button halfway, 
move to the desired composition and press the 
button all the way.
• The card access lamp blinks while the picture is 
being stored on the card.
If the subject has lower contrast than its surroundings
If the contrast of the subject is weak, such as when the lighting is insufficient or the subject 
cannot be seen clearly because of fog, the focus may not be achieved. Focus (focus lock) on 
a high-contrast object the same distance away as the intended subject, recompose your shot 
and then take the picture.
Focus lock 
k If correct focus cannot be obtained
Card access lamp
Shutter button
250
250
250 F5.6
F5.6
38
38
P
L N
N
e.g.) The camera focuses using the 
center AF target.
38
38
P
L N
N
250
250
250 F5.6
F5.6
AF confirmation mark
s0019_e_00_0_unified.book  Page 60  Friday, April 24, 2009  9:21 AM