Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 ソフトウェアガイド

Use this command to clear all entries in the MLD traffic database.

MLD-Proxy is the IPv6 equivalent of IGMP-Proxy. MLD-Proxy commands allow you to 
configure the network device as well as to view device settings and statistics using either 
serial interface or telnet session. The operation of MLD-Proxy commands is the same as for 
IGMP-Proxy: MLD is for IPv6 and IGMP is for IPv4.MGMD is a term used to refer to both 
IGMP and MLD.

Use this command to enable MLD-Proxy on the interface or range of interfaces. To enable 
MLD-Proxy on the interface, you must enable multicast forwarding. Also, make sure that 
there are no other multicast routing protocols enabled on the router.

Use this command to disable MLD-Proxy on the router. 

Use this command to set the unsolicited report interval for the MLD-Proxy interface or range 
of interfaces. This command is only valid when you enable MLD-Proxy on the interface. The 
value of interval is 1-260 seconds.

Format

clear ipv6 mld traffic

Mode

Privileged Exec

Format

ipv6 mld-proxy

Mode

Interface Config

Format

no ipv6 mld-proxy

Mode

Interface Config

Default

1

Format

ipv6 mld-proxy unsolicit-rprt-interval interval

Mode

Interface Config