Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 ソフトウェアガイド
Switching Commands
575
M4200 and M4300 Series ProSAFE Managed Switches
Command example:
(Netgear Switch) #show mldsnooping proxy-querier
Admin Mode..................................... Enable
Interfaces Enabled for MLD Proxy Querier....... 1/0/1
1/0/2
1/0/3
Port Security Commands
This section describes the command you use to configure Port Security on the switch. Port
security, which is also known as port MAC locking, allows you to secure the network by
locking allowable MAC addresses on a given port. Packets with a matching source MAC
address are forwarded normally, and all other packets are discarded.
security, which is also known as port MAC locking, allows you to secure the network by
locking allowable MAC addresses on a given port. Packets with a matching source MAC
address are forwarded normally, and all other packets are discarded.
Note:
To enable the SNMP trap specific to port security, see
port-security
This command enables port locking on an interface, a range of interfaces, or at the system
level.
level.
no port-security
This command disables port locking for one (Interface Config) or all (Global Config) ports.
Default
disabled
Format
port-security
Mode
Global Config (to enable port locking globally)
Interface Config (to enable port locking on an interface or range of interfaces)
Format
no port-security
Mode
Global Config
Interface Config