Netgear WC7520 - ProSafe 20-AP Wireless Controller 参照マニュアル
Configuring Network Access and Security
114
ProSafe 20-AP Wireless Controller WC7520
Configure Basic Rogue Detection Settings
In a basic setup you can set up one detection server. In an advanced setup you can create
multiple detection servers (for more information, see
multiple detection servers (for more information, see
Note:
If there are long delays in the network or clients are unexpectedly
disconnected from access points, disable rogue access point
detection and mitigation.
detection and mitigation.
To set up a server to detect rogue access points:
1.
Select Configuration > Security > Basic > Rogue AP. The basic Rogue AP screen
displays:
displays:
Figure 53.
The wireless controller can support a total of up to 512 access points from the known and
unknown lists combined.
unknown lists combined.
2.
Configure the settings as explained in the following table:
Table 27. Basic rogue AP detection settings
Setting
Description
Rogue AP Detection
Select the Enable radio button to enable rogue AP detection, and to allow all
neighbor as well as rogue access points to be displayed. A maximum of
512 access points (both neighbor and rogue) can be detected and maintained
on the controller. The controller also maintains current count of the rogue access
points as well rogue access points detected in the last 24 hours.
neighbor as well as rogue access points to be displayed. A maximum of
512 access points (both neighbor and rogue) can be detected and maintained
on the controller. The controller also maintains current count of the rogue access
points as well rogue access points detected in the last 24 hours.
When external storage is present, rogue access point information is saved for
72 hours.
72 hours.
To disable rogue AP detection, select the Disable radio button.