Netgear WC7520 - ProSafe 20-AP Wireless Controller 参照マニュアル
Maintaining the Controller
140
ProSafe 20-AP Wireless Controller WC7520
Figure 66.
To reboot the wireless controller:
1.
Select the Reboot radio button.
2.
Click Apply to save your settings. The wireless controller reboots. The reboot process is
complete after several minutes when the Test LED on the front panel goes off.
complete after several minutes when the Test LED on the front panel goes off.
To reset the wireless controller:
1.
Select the Reset radio button.
2.
Select one of the following radio buttons to specify a hard reset or soft reset:
-
Hard. Restore the factory default settings (which are listed in
) to the wireless controller.
-
Soft. Clear all settings except for the IP addresses, floor plans, and managed access
point list.
point list.
3.
Click Apply to save your settings. If you selected a hard reset, the wireless controller
reboots.
reboots.
Note:
Restoring the factory default settings of the wireless controller does
not restore the settings of the access points that are managed by the
wireless controller.
wireless controller.
WARNING!
If you perform a hard reset, do not try to go online, turn off the
wireless controller, shut down the computer, or do anything else
to the wireless controller until the wireless controller finishes
rebooting! When the LED light turns off, wait a few more seconds
before you do anything.
wireless controller, shut down the computer, or do anything else
to the wireless controller until the wireless controller finishes
rebooting! When the LED light turns off, wait a few more seconds
before you do anything.