Netgear WC7520 - ProSafe 20-AP Wireless Controller 参照マニュアル
System Planning and Deployment Scenarios
36
ProSafe 20-AP Wireless Controller WC7520
Figure 12.
The access points and wireless controller are connected in the same subnet and same VLAN
and use the same IP address range that is assigned for that subnet. There are no routers
between the access points and the wireless controller. The access points are connected to a
PoE switch, which, in turn, is connected to the wireless controller. The uplink of the PoE
switch connects to a Layer 3 switch or router that provides Internet access.
and use the same IP address range that is assigned for that subnet. There are no routers
between the access points and the wireless controller. The access points are connected to a
PoE switch, which, in turn, is connected to the wireless controller. The uplink of the PoE
switch connects to a Layer 3 switch or router that provides Internet access.
Prerequisites
This network configuration has the following prerequisites:
•
VLANs 10, 20, and 100 are tagged VLANs and are configured on both the wireless
controller and the PoE switch.
•
The wireless controller is connected to the PoE switch through default VLAN 1. You
manage the wireless controller from a computer over VLAN 1 through the PoE switch.
•
The DHCP server on the wireless controller is configured in management VLAN 100 to
enable the access points to receive an IP address through VLAN 100.
•
The PoE switch port to which the wireless controller is connected is configured as a
tagged port to allow tagged traffic from VLAN 100.