Netgear WC7520 - ProSafe 20-AP Wireless Controller 参照マニュアル

Configure the basic system settings:

1. Configure the country code of operation.

2. Configure the IP address of wireless controller.

3. Verify that VLAN 1 is set as the management VLAN and is 

marked as untagged, which is the default setting.

Configure the following profiles, and configure network 
authentication and data encryption for these profiles:

1. A profile with SSID 1 and VLAN 10.

2. A profile with SSID 2 and VLAN 20.

3. A profile with SSID 2 and VLAN 30.

4. A profile with SSID 3 and VLAN 40.

Configure the following profile groups:

1. A profile group with the name Building 1, to which you add the 

following profiles:

- The profile with SSID 1 and VLAN 10

- The profile with SSID 2 and VLAN 20

- The profile with SSID 2 and VLAN 30

2. A profile group with the name Building 2, to which you add the 

following profiles:

- The profile with SSID 1 and VLAN 10

- The profile with SSID 2 and VLAN 30

- The profile with SSID 3 and VLAN 40

Deploy the access points and connect them to PoE switches.

 

Wait until the access points are up and running, run the Discovery 
Wizard, specify the network layout by selecting the Same L2 
network radio button, and select the access points that you want to 
be managed by the wireless controller.

Assign the access points to the access point profile groups (also 
referred to as WLAN groups).