Netgear NMS200 – ProSafe Network Management System ユーザーズマニュアル

Image Type — A read-only reminder of the type of image.

Select Targets for Deployment — Select targets for deploying the image. This 

defaults to the device right-clicked in Managed Resources to initiate this action, or 
devices that match the selected file you want to deploy. You can then click the Add 
Equipment button (again, restricted to devices that match the deploy file’s type). You 
can also remove devices from the target list with the Remove All button. Notice the 
Status column in the table of targets shows whether the OS deployment is supported 
or not.

You can also select devices, then change the OS selection so a 

potential mismatch will occur. This will likely trigger rejection of the 
deployment by the device, but is not a recommended experiment.

Device Options — The appearance of the Device Options panel, at the bottom of this 
screen, depends on the device selected in the Targets panel. These vendor-specific 
fields let you fine-tune the deployment. 

Click one of the buttons at the bottom of the screen to initiate the next backup action.

Add Schedule opens the scheduling screen to let you automate the backup you have 
configured on a specified date, time, or repetition. See 

Execute performs the backup immediately. The Results tab in this screen opens, 
displaying the message traffic between NMS200 and the device(s). See 

on page 46.

Save preserves this configuration without scheduling or executing it.

Close closes this screen without saving the configured backup.

Contacts

The contact manager displays available contacts for your system. There is no expanded 
version of this portlet.

You can right-click to create, modify or remove (New, Open, Delete) the selected contact. You 
can also Import, Export All (see 

on page 42) or Share with User (see 

on page 43).