Netgear FVM318 – Cable and DSL ProSafe Wireless VPN Security Firewall 参照マニュアル
Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall
5-6
Virtual Private Networking
2.
Configure the VPN settings on each FVM318.
a.
From Setup section of the main menu of the FVM318, click the VPN Settings link. Click
Add. The VPN Settings - Main Mode window opens as shown below:
Add. The VPN Settings - Main Mode window opens as shown below:
Figure 5-4: VPN Settings - Main Mode IKE Edit menu
b.
Fill in the Connection Name VPN settings as illustrated.
•
The Connection Names of LANs A and B can be the same: VPNAB
•
Local IPSec Identifier name in the FVM318 on LAN A: LAN_A
Note: This IPSec name must not be used in any other SA in this VPN network.
•
Local IPSec Identifier in the FVM318 on LAN B: LAN_B
•
Remote IPSec Identifier in the FVM318 on LAN A: LAN_B
•
Remote IPSec Identifier in the FVM318 on LAN B: LAN_A
•
Remote LAN IP Address in the FVM318 on LAN A: 192.168.0.1
and Remote Subnet Mask in the FVM318 on LAN A: 255.255.255.0
This is the LAN IP Address for the FVM318 on LAN B.
Note: With these IP settings, using this VPN tunnel, you can connect to any device on
LAN B. Alternatively, you can specify the IP address of a single address on LAN B
and a Subnet Mask of 255.255.255.255 which will limit the VPN tunnel to connecting
to just that device.
LAN B. Alternatively, you can specify the IP address of a single address on LAN B
and a Subnet Mask of 255.255.255.255 which will limit the VPN tunnel to connecting
to just that device.
LAN A
LAN B