Netgear FVX538v1 – ProSafe VPN Firewall Dual WAN with 8-Port 10/100 and 1 Gigabit LAN Port Switch 参照マニュアル

2-4

Connecting the FVX538 to the Internet

4. Set up the traffic meter for WAN 1 ISP if desired. See 

The configure the WAN2 ISP settings:

1. Repeat the above steps to set up the parameters for WAN2 ISP. Start by selecting the WAN2 

ISP Settings tab. Next click Auto Detect on the WAN2 ISP Settings screen and then confirm 
the connection by clicking the WAN Status link.

2. Set up the traffic meter for WAN2 ISP, if desired. See 

Each computer or router on your network has a unique 48-bit local Ethernet address. This is also 
referred to as the computer's MAC (Media Access Control) address. The default is set to Use 
Default Address. If your ISP requires MAC authentication and another MAC address has been 
previously registered with your ISP, then you must enter that address. Setting the router’s MAC 
address is controlled through the Advanced options on the WAN1 ISP Settings and WAN2 ISP 
Settings screen (see

).

If you know your ISP connection type, you can bypass the Auto Detect feature and connect your 
router manually. Ensure that you have all of the relevant connection information such as IP 
Addresses, account information, type of ISP connection, etc., before you begin. Unless your ISP 
automatically assigns your configuration automatically via DHCP, you will need the configuration 
parameters from your ISP (see 

).

To manually configure your WAN1 ISP Settings:

1. Does your Internet connection require a login? If you need to enter login information every 

time you connect to the Internet through your ISP, select Yes. Otherwise, select No. 

Note: At this point of the configuration process, you are now connected to the 

Internet through WAN port 1. But you must continue with the configuration 
process to get the complete functionality of the dual WAN interface.

Note: To enable a WAN port to respond to a Ping from the Internet, use the Rules menu