Netgear UTM9S – ProSECURE Unified Threat Management (UTM) Appliance with DSL and Wireless modules 参照マニュアル

Rear Panel UTM5, UTM10, and UTM25

The rear panel of the UTM includes a cable lock receptacle, a console port, a factory default 
Reset button, and an AC power connection.

Viewed from left to right, the rear panel of the UTM5, UTM10, and UTM25 contains the 
following components:

Cable security lock receptacle.

Console port. Port for connecting to an optional console terminal. The port has a DB9 male 
connector. The default baud rate is 9600 K. The pinouts are (2) Tx, (3) Rx, (5) and (7) Gnd.

Factory default Reset button. Using a sharp object, press and hold this button for about 
8 seconds until the front panel Test LED flashes to reset the UTM to factory default settings. 
Configuration changes are lost, and the default password is restored.

AC power receptacle. Universal AC input (100–240 VAC, 50–60 Hz).

Wireless 
Link LED

Off

The wireless access point is not enabled.

On (green)

The wireless access point is enabled in 2.4-GHz operating mode.

Blinking (green)

There is wireless activity in 2.4-GHz operating mode.

On (yellow)

The wireless access point is enabled in 5-GHz operating mode.

Blinking (yellow)

There is wireless activity in 5-GHz operating mode.

Module 
Status LED

Off

The module is enabled or has a link the the telephone line.

On (green)

The module either is not enabled or has no link to the telephone line.

Link LED

Off

The xDLS port has no Internet connection.

On (green)

The xDSL port functions in ADSL mode.

On (yellow)

The xDSL port functions in VDSL mode.