Netgear UTM9S – ProSECURE Unified Threat Management (UTM) Appliance with DSL and Wireless modules 参照マニュアル

Click Apply to save your settings.

Manage the Configuration File

The configuration settings of the UTM are stored in a configuration file on the UTM. This file 
can be saved (backed up) to a PC, retrieved (restored) from the PC, or cleared to factory 
default settings.

Once the UTM is installed and works correctly, make a backup of the configuration file to a 
computer. If necessary, you can later restore the UTM settings from this file. 

The Backup & Restore Settings screen lets you:

Back up and save a copy of the current settings

Restore saved settings from the backed-up file

Revert to the factory default settings

To display the Backup & Restore Settings screen, select Administration > Backup & 
Restore Settings.

Enable Access From 
WAN

Select the Enable Access From WAN check box to allow SNMP management 
over a WAN connection. This check box is cleared by default, allowing SNMP 
management only over a LAN connection.

Enter the IP addresses of the computers and devices to which you want to grant read-only (GET) or write 
(SET) privileges on the UTM. Separate IP addresses by a comma. To allow any trusted SNMP host access, 
leave the field blank, which is the default setting.

Enter the IP addresses of the SNMP management stations that are allowed to receive the UTM’s SNMP 
traps. Separate IP addresses by a comma. If you leave the field blank, which is the default setting, no 
SNMP management station can receive the UTM’s SNMP traps.