Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ハードウェアマニュアル
Chapter 20. IPv6 Unicast Commands
|
904
20
20.
IPv6 Unicast Commands
This chapter describes commands for configuring and managing the following IPv6 features:
•
IPv6 unicast routing
•
Route sharing
•
Route compression
•
IP multinetting
For an introduction to these IPv6 features, see the NETGEAR 8800 User Manual.
clear neighbor-discovery cache
clear neighbor-discovery cache ipv6 {<ipv6address> {vr <vr_name>} | vlan <vlan_name> | vr
<vr_name>}
Description
Deletes a dynamic entry from the neighbor cache.
Syntax Description
Default
N/A.
Usage Guidelines
This command clears dynamic entries from the neighbor cache. The
vr
option is used to
specify the virtual router on which the operation is performed. When this option is omitted it
applies to VR-Default.
applies to VR-Default.
When the ipv6address or vlan options are specified, only the entries with matching IPv6
addresses or that correspond to that VLAN are cleared.
addresses or that correspond to that VLAN are cleared.
vr_name
Specifies a virtual router.
ipv6address
Specifies an IPv6 address.
vlan_name
Specifies an IPv6 configured VLAN.