Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル
164
|
Chapter 6. LLDP
NETGEAR 8800 User Manual
Network policy TLV
You configure this MED TLV to allow both network connectivity devices and endpoint devices
to advertise VLAN configuration and associated Layer 2 and Layer 3 attributes that apply for
a specific set of applications on that port.
to advertise VLAN configuration and associated Layer 2 and Layer 3 attributes that apply for
a specific set of applications on that port.
You configure this TLV per port/VLAN. Each application can exist only once on each port. You
can configure a maximum of 8 TLVs, each with its own DSCP value and/or priority tag. This
TLV tells the endpoint the specific VLAN to use for the specific application.
can configure a maximum of 8 TLVs, each with its own DSCP value and/or priority tag. This
TLV tells the endpoint the specific VLAN to use for the specific application.
Location identification TLV
You configure this TLV to advertise or not advertise a maximum of three different location
identifiers, each with a different format, as follows:
identifiers, each with a different format, as follows:
•
Coordinate based, using a 16-byte hexadecimal string
•
Civic-based, using a hexadecimal string with a minimum of 6 bytes
•
ECS ELIN, using a numerical string with a range of 10 to 25 characters.
Extended power-via-MDI TLV
Use this TLV to advertise fine-grained power requirement details, including the power status
of the PD and the port. You can enable this TLV only on PoE-capable ports; the switch
returns an error message if you attempt to transmit this LLDP TLV over a non-PoE-capable
port.
of the PD and the port. You can enable this TLV only on PoE-capable ports; the switch
returns an error message if you attempt to transmit this LLDP TLV over a non-PoE-capable
port.
Configuring LLDP
You configure LLDP per port. To configure LLDP:
1.
Enable LLDP on the desired port(s).
2.
If desired, configure the system not to advertise the system description TLV.
3.
If you want to change any default values, configure the following values:
a. Reinitialize period
b. Transmit interval
c. Transmit delay
d. Transmit hold
4.
Enable the SNMP traps and configure the notification interval.
5.
Configure any optional TLV advertisements,that you want included in the LLDPDU.
6.
If you want to send or receive MED extension TLVs, configure the LLDP MED capabilities
TLV.
TLV.
7.
If you want to change the default value of 3 for the fast-start feature for LLDP MED,
configure the LLDP MED fast-start TLVs.
configure the LLDP MED fast-start TLVs.
8.
If you want SNMP traps for the LLDP MED extension TLVs, enable these traps.