Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル
184
|
Chapter 7. PoE
NETGEAR 8800 User Manual
Adding an XCM88P Daughter Card to an Existing
Configuration
XCM8848T I/O Modules for the NETGEAR 8800 Series Switches
This section describes how to add an XCM88P daughter card to a NETGEAR 8800 switch
configuration that has already been saved without PoE capabilities.
configuration that has already been saved without PoE capabilities.
The following output displays the results of the
show slot
command with slot 4 configured:
* XCM8806.2 #
* XCM8806.2 # show slot
Slots Type Configured State Ports Flags
-------------------------------------------------------------------------------
Slot-1 XCM8824F XCM8824F Operational 24 MB
Slot-2 XCM8824F Empty 24
Slot-3 XCM888F XCM888F Operational 8 MB
Slot-4 Empty 0
Slot-5 XCM8808X XCM8808X Operational 8 MB
Slot-6 XCM8848T XCM8848T Operational 48 MB
MSM-A XCM88S1 Operational 0
MSM-B XCM88S1 Operational 0
Flags : M - Backplane link to Master is Active
B - Backplane link to Backup is also Active
D - Slot Disabled
I - Insufficient Power (refer to "show power budget")
To configure a module for the PoE daughter card:
1.
Remove the XCM8848T module.
2.
Attach the PoE daughter card to the XCM8848T module (as described in installation
document provided with the daughter card).
document provided with the daughter card).
3.
Re-insert the XCM8848T module with the PoE daughter card attached. The following output
displays the results of the
displays the results of the
show slot
command after the card is attached:
* XCM8806.2 #
* XCM8806.2 # show slot
Slots Type Configured State Ports Flags
-------------------------------------------------------------------------------
Slot-1 XCM8824F XCM8824F Operational 24 MB
Slot-2 XCM8824F Empty 24
Slot-3 XCM888F XCM888F Operational 8 MB
Slot-4 Empty 0
Slot-5 XCM8808X XCM8808X Operational 8 MB