Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル

handling setting appears in parenthesis next to the polling setting. For more information 
about the fault handling setting, see 

on page 206.

In the following truncated output from a NETGEAR 8810 switch, the system health check 
setting appears as 

SysHealth check: Enabled (Normal)

:

SysName:          TechPubs Lab

SysName:          XCM8810

SysLocation:

SysContact:       support@netgear.com

System MAC:       00:04:96:1F:A2:60

SysHealth check:  Enabled (Normal)

Recovery Mode:    None

System Watchdog:  Enabled

System Health Check Examples: Diagnostics

This section provides examples for using the system health checker on the NETGEAR 8800 
series switches. For more detailed information about the system health check commands, 
see the chapter on commands for status monitoring and statistics in the NETGEAR 8800 
Chassis Switch CLI Manual. 

This section describes a series of two examples for:

Enabling and configuring backplane diagnostics

Disabling backplane diagnostics

The following example:

Enables backplane diagnostic packets on slot 3 

Configures backplane diagnostic packets to be sent every 7 seconds

Enable backplane diagnostic packets on slot 3 using the following command:

enable sys-health-check slot 3

 

When you enable backplane diagnostic packets on slot 3, the timer runs at the default 
rate of 5 seconds.

Configure backplane diagnostic packets to be sent every 7 seconds using the following 
command:

configure sys-health-check interval 7