Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル

When you add a port to a VR, that port can only be used by that VR.

To add a port to a single VR, use the following command:

configure vr <vr-name> add ports <portlist>

The following example demonstrates how to remove all the ports on slot 3 from the Default 
VLAN in VR-Default and add them for the exclusive use of user VR helix:

configure vlan default delete ports 3:*

configure vr vr-default delete ports 3:*

configure vr helix add ports 3:*

To use a port in multiple VRs, do not add the port to a VR, as described in the previous 
section. Add the port to a VLAN in the desired VR.

See 

 for details about how multiple VRs per port 

can affect DiffServ and code replacement.

You should configure any protocols you want to use on a user VR 

before you add a VLAN to the user VR. When IP multicast 
forwarding will be supported on a user VR, add the PIM protocol 
before you enable IP multicast forwarding.

The following example demonstrates how to add port 3:5 to user VRs VR-green and 
VR-blue. The tagged VLAN bldg_200 was previously configured in VR-green, and the tagged 
VLAN bldg_300 was previously configured in VR-blue.

configure vlan default delete ports 3:5

configure vr vr-default delete ports 3:5

configure vlan bldg_200 add ports 3:5 tagged

configure vlan bldg_300 add ports 3:5 tagged

Displaying Ports and Protocols

You can display the ports, protocols, and names of protocol processes for a VR by using the 
following command:

show virtual-router {<vr-name>}