Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル
Chapter 3. Managing the Switch
|
53
NETGEAR 8800 User Manual
Note:
For more information on the console port pinouts, see the hardware
installation guide included with your switch.
After the connection has been established, you see the switch prompt and you can log in.
Using the 10/100 Ethernet Management Port
The management module provide a dedicated 10/100 Mbps Ethernet management port. This
port provides dedicated remote access to the switch using TCP/IP. It supports the following
management methods:
port provides dedicated remote access to the switch using TCP/IP. It supports the following
management methods:
•
Telnet/SSH2 using the CLI interface
•
SNMP access using EPICenter or another SNMP manager
The switch uses the Ethernet management port only for host operation, not for switching or
routing. The TCP/IP configuration for the management port is done using the same syntax as
used for virtual LAN (VLAN) configuration. The VLAN mgmt comes preconfigured with only
the management port as a member. The management port is a member of the virtual router
VR-Mgmt.
routing. The TCP/IP configuration for the management port is done using the same syntax as
used for virtual LAN (VLAN) configuration. The VLAN mgmt comes preconfigured with only
the management port as a member. The management port is a member of the virtual router
VR-Mgmt.
When you configure the IP address for the VLAN mgmt, this address gets assigned to the
primary MSM/MM. You can connect to the management port on the primary MSM/MM for any
switch configuration. The management port on the backup MSM/MM is available only when
failover occurs. At that time, the primary MSM/MM relinquishes its role, the backup MSM/MM
takes over, and the VLAN mgmt on the new primary MSM/MM acquires the IP address of the
previous primary MSM/MM.
primary MSM/MM. You can connect to the management port on the primary MSM/MM for any
switch configuration. The management port on the backup MSM/MM is available only when
failover occurs. At that time, the primary MSM/MM relinquishes its role, the backup MSM/MM
takes over, and the VLAN mgmt on the new primary MSM/MM acquires the IP address of the
previous primary MSM/MM.
To configure the IP address and subnet mask for the VLAN mgmt, use the following
command:
command:
configure vlan mgmt ipaddress <ip_address>/<subnet_mask>
To configure the default gateway (you must specify VR-Mgmt for the management port and
VLAN mgmt), use the following command:
VLAN mgmt), use the following command:
configure iproute add default <gateway> {<metric>} {multicast | multicast-only | unicast |
unicast-only} {vr <vrname>}
The following example configuration sets the management port IP address to 192.168.1.50,
mask length of 25, and configures the gateway to use 192.168.1.1:
mask length of 25, and configures the gateway to use 192.168.1.1:
configure vlan mgmt ipaddress 192.168.1.50/25
configure iproute add default 192.168.1.1 vr vr-mgmt
Authenticating Users
XCM8800 provides three methods to authenticate users who log in to the switch:
•
RADIUS client