Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル

Configuring Basic IP Unicast Routing

To configure basic IP unicast routing, do the following:

Create and configure two or more VLANs.

Assign each VLAN that will be using routing an IP address using the following command:

configure {vlan} <vlan_name> ipaddress [<ipaddress> {<ipNetmask>} | ipv6-link-local | 
{eui64} <ipv6_address_mask>]

Ensure that each VLAN has a unique IP address.

Configure a static route using the following command:

configure iproute add <ipv6Netmask> [<ipv6Gateway> | <ipv6ScopedGateway>] 
{<metric>} {vr <vrname>} {multicast | multicast-only | unicast | unicast-only}

or

Configure a default route using the following command:

configure iproute add default [<ipv6Gateway> | <ipv6ScopedGateway>] {metric} {vr 
<vrname>} {multicast-only | unicast-only}

Default routes are used when the router has no other dynamic or static route to the 
requested destination.

Turn on IP routing for one or all VLANs using the following command:

enable ipforwarding ipv6 {vlan <vlan_name> | tunnel <tunnel-name> | vr 

<vr_name>}

Configure the routing protocol, if required. For a simple network using RIPng, the default 
configuration may be acceptable. 

Turn on RIPng or OSPFv3 using one of the following commands:

enable ripng

enable ospfv3 {domain <domainName>}

Managing Neighbor Discovery

The following sections describe how to manage neighbor discovery:

•     Creating and Deleting Static Entries 

•     Configuring the Neighbor-Discovery Cache Size 

•     Managing Neighbor-Discovery Cache Updates 

•     Clearing the Neighbor-Discovery Cache 

•     Returning to the Neighbor-Discovery Cache Default Configuration 

•     Displaying Neighbor-Discovery Cache Entries