Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル

If you override automatic power supply management, you may 

reduce the available power and cause one or more I/O modules to 
power down. 

To resume using automatic power supply management on a PSU, use the 

configure power 

supply

 

<ps_num> auto

 command. The setting for each PSU is stored as part of the switch 

configuration.

To display power supply status and power budget information, use the 

show power

 and 

show 

power budget

 commands. 

Displaying Power Supply Information

To display the status of the currently installed power supplies on all switches, use the 
following command:

show power {<ps_num>} {detail} 

On modular switches, the following commands provide additional power supply information.

To view the system power status and the amount of available and required power, use the 
following command:

show power budget 

To display the status of the currently installed power supply controllers on modular switches, 
use the following command:

show power controller {<num>} 

Using the Simple Network Management Protocol

Any network manager program running the Simple Network Management Protocol (SNMP) 
can manage the switch, provided the Management Information Base (MIB) is installed 
correctly on the management station. Each network manager program provides its own user 
interface to the management facilities. 

When using a network manager program to create a VLAN, 

NETGEAR does not support the SNMP create and wait operation. 
To create a VLAN with SNMP, use the create and go operation. 

The following sections describe how to get started if you want to use an SNMP manager. It 
assumes you are already familiar with SNMP management. If not, see the following 
publication: