Netgear M6100 – Campus Edge and SMB Core Chassis Switches ソフトウェアガイド
1151
16
16.
IPv6 Multicast Commands
The entire IPv6 Multicast commands section is Enterprise-only. This chapter describes the IPv6
Multicast commands available in the NETGEAR Managed Switch CLI.
Multicast commands available in the NETGEAR Managed Switch CLI.
The chapter contains the following sections:
•
•
•
•
Only the following switches support IPv6 multicast:
•
M6100
•
M5300-28G3
•
M5300-52G3
•
M5300-28GF3
The following switches support IPv6 multicast with an L3 license:
•
M5300-28G
•
M5300-52G
•
M5300-28G-POE+
•
M5300-52G-POE+
Note:
No specific command exists to enable multicast for IPv6. If you
enable multicast with a global config command, multicast is enabled
for both IPv4 and IPv6.
enable multicast with a global config command, multicast is enabled
for both IPv4 and IPv6.
The commands in this chapter are in one of three functional groups:
•
Show commands. Display switch settings, statistics, and other information.
•
Configuration commands. Configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
configuration command, there is a show command that displays the configuration setting.