Netgear M6100 – Campus Edge and SMB Core Chassis Switches ソフトウェアガイド

This command displays the VLAN associated with a specific configured IP-Address and net 
mask. If no IP address and net mask are specified, the VLAN associations of all the 
configured IP-subnets are displayed.

This command displays the VLAN associated with a specific configured MAC address. If no 
MAC address is specified, the VLAN associations of all the configured MAC addresses are 
displayed.

This section describes the commands used for switch port mode.

Use this command to configure the mode of a switch port as access, trunk, or general:

Trunk mode. In trunk mode, the port becomes a member of all VLANs on the switch 
unless specified in the allowed list in the switchport trunk allowed vlan 
command. The PVID of the port is set to the native VLAN as specified in the 
switchport trunk native vlan

 command. This means that trunk ports accept both 

tagged and untagged packets. Untagged packets are processed on the native VLAN and 
tagged packets are processed on the VLAN for which the ID is contained in the packet. 
MAC learning is performed on both tagged and untagged packets. Tagged packets that 

Format

show vlan association subnet [ipaddr netmask]

Mode

Privileged EXEC 

IP Address

The IP address assigned to each interface.

Net Mask

The subnet mask.

VLAN ID

There is a VLAN Identifier (VID) associated with each VLAN.

Format

show vlan association mac [macaddr]

Mode

Privileged EXEC 

Mac Address

A MAC address for which the switch has forwarding and or filtering information. The format is 6 or 8 

two-digit hexadecimal numbers that are separated by colons, for example 01:23:45:67:89:AB. In an 
IVL system the MAC address will be displayed as 8 bytes.

VLAN ID

There is a VLAN Identifier (VID) associated with each VLAN.