Netgear M6100 – Campus Edge and SMB Core Chassis Switches ソフトウェアガイド
Routing Commands
667
M5300, M6100, and M7100 Series ProSAFE Managed Switches
IP Routing Commands
This section describes the commands you use to enable and configure IP routing on the
switch.
switch.
routing
This command enables IPv4 and IPv6 routing for an interface or range of interfaces. You can
view the current value for this function with the show ip brief command. The value is
labeled as Routing Mode.
view the current value for this function with the show ip brief command. The value is
labeled as Routing Mode.
no routing
This command disables routing for an interface.
You can view the current value for this function with the show ip brief command. The
value is labeled as Routing Mode.
value is labeled as Routing Mode.
ip routing
This command enables the IP Router Admin Mode for the supervisor blade.
Term
Definition
IP Address
The IP address of a device on a subnet attached to the switch.
MAC Address
The hardware MAC address of that device.
Interface
The routing unit/slot/port associated with the device’s ARP entry.
Default
disabled
Format
routing
Mode
Interface Config
Format
no routing
Mode
Interface Config
Format
ip routing
Mode
Global Config