Netgear M6100 – Campus Edge and SMB Core Chassis Switches 管理者ガイド

NETGEAR managed switches support a single set of default configurations and scaling 
parameters, which are hard-coded in the factory default configuration file. To enable you to 
use a different set of default configurations and scaling parameters, you can override the 
factory default configuration file and specify that another file in the file system must be 
regarded as the factory defaults. After you issue the clear config privileged EXEC 
command, the switch uses the new factory defaults.

Create a new factory default configuration file.

The file format must be the same as the format of the startup configuration file. 

Disable STP and LLDP MED on all interfaces. 

If the switch is not configured for STP and LLDP MED, you can skip this step.

(Netgear Switch) #configure

(Netgear Switch) (Config)#no spanning-tree

(Netgear Switch) (Config)#no lldp med all

Save the new factory default configuration file as a text file named factory_default.txt.

Download the factory_default.txt file to the switch.

(Netgear Switch) #copy tftp://172.26.2.100/factory_default.txt nvram:factory-defaults 

Mode........................................... TFTP  

Set Server IP.................................. 172.26.2.100

Path........................................... ./

Filename....................................... factory_default.txt

Data Type...................................... Text Configuration

Download configuration file. Configuration will be applied upon next reboot.

Management access will be blocked for the duration of the transfer

Are you sure you want to start? (y/n) y

File transfer in progress. Management access will be blocked for the duration of the 
transfer. please wait...

File transfer successful..