Netgear M6100 – Campus Edge and SMB Core Chassis Switches 管理者ガイド
(Switch S) #show ip vrrp interface vlan 300 1
Primary IP address............................. 192.168.103.3
VMAC Address................................... 00:00:5e:00:01:01
Authentication Type............................ None
Priority....................................... 100
Configured Priority............................ 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Enable
Accept Mode.................................... Disable
State.......................................... Master
Track Interface State DecrementPriority
--------------- ----- ------------------
No interfaces are tracked for this vrid and interface combination
Track Route(pfx/len) Reachable DecrementPriority
--------------------- --------- ------------------
No routes are tracked for this vrid and interface combination
MLAGs
90
Managed Switches
Web Interface: Enable Routing on MLAG Interfaces
Configure Switch P
Note:
For information about switch P, see
description following the figure.
1.
On switch P, configure IP address 192.168.100.1 on VLAN 100, IP address
192.168.102.1 on VLAN 200, and IP address 192.168.103.1 on VLAN 300.
192.168.102.1 on VLAN 200, and IP address 192.168.103.1 on VLAN 300.
For information about configuring IP addresses, see
and
.
2.
Configure VRRP on VLAN 100 on switch P.
a. Select Routing > VRRP > Basic > VRRP Configuration.