Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch ハードウェアマニュアル

C.   

Notification of Compliance

It is hereby certified that the NETGEAR ProSafe 10Gigabit Managed L2+ Stackable Switch XSM7224S has been 
suppressed in accordance with the conditions set out in the BMPT-AmtsblVfg 243/1991 and Vfg 46/1992.The 
operation of some equipment (for example, test transmitters) in accordance with the regulations may, however, be 
subject to certain restrictions. Please refer to the notes in the operating instructions. 

Federal Office for Telecommunications Approvals has been notified of the placing of this equipment on the market and 
has been granted the right to test the series for compliance with the regulations. 

This is Class A product based on the standard of the Voluntary Control Council for Interference by Information 
Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio interference may occur, in 
which case, the user may be required to take corrective actions.”

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 

This device may not cause harmful interference. 

This device must accept any interference received, including interference that may cause undesired operation. 

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a 
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following measures: 

Reorient or relocate the receiving antenna. 

Increase the separation between the equipment and receiver. 

Connect the equipment into an outlet on a circuit different from that which the receiver is connected. 

Consult the dealer or an experienced radio/TV technician for help. 

This digital apparatus (NETGEAR ProSafe 10Gigabit Managed L2+ Stackable Switch XSM7224S) does not exceed 
the Class A limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of 
the Canadian Department of Communications.