Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch プリント

Virtual LAN Routing Commands

This section describes the commands you use to view and configure VLAN routing and to 
view VLAN routing status information.

This command enables routing on a VLAN. The vlanid value has a range from 1 to 4093. The 
[interface ID] value has a range from 1 to 128. Typically, you will not supply the interface ID 
argument, and the system automatically selects the interface ID. However, if you specify an 
interface ID that is already in use, the CLI displays an error message and does not create the 
VLAN interface. 

vlan routing <vlanid> [interface ID]

This command deletes routing on a VLAN. The <vlanid> value has a range from 1 to 4093. 

no vlan routing <vlanid>

The <unit/slot/port> that matches the rest of the information in the row.

The advertise mode, which indicates whether router discovery is enabled or disabled on 
this interface.

The IP address to which the interface sends the advertisement.

The maximum advertise interval, which is the maximum time, in seconds, allowed 
between sending router advertisements from the interface.

The minimum advertise interval, which is the minimum time, in seconds, allowed 
between sending router advertisements from the interface.

The amount of time, in seconds, that a system should keep the router advertisement 
before discarding it.

The preference of the address as a default router address, relative to other router 
addresses on the same subnet.

VLAN Config

VLAN Config