Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch プリント
Switching Commands
43
ProSafe Managed Switch
Spanning Tree Protocol (STP) Commands
This section describes the commands you use to configure Spanning Tree Protocol (STP).
STP helps prevent network loops, duplicate messages, and network instability.
STP helps prevent network loops, duplicate messages, and network instability.
spanning-tree
This command sets the spanning-tree operational mode to enabled.
Default
Format
spanning-tree
Mode
no spanning-tree
This command sets the spanning-tree operational mode to disabled. While disabled, the
spanning-tree configuration is retained and can be changed, but is not activated.
spanning-tree configuration is retained and can be changed, but is not activated.
Format
no spanning-tree
Mode
spanning-tree bpdufilter
Use this command to enable BPDU Filter on an interface or range of interfaces.
Default
Format
spanning-tree bpdufilter
Mode
no spanning-tree bpdufilter
Use this command to disable BPDU Filter on the interface or range of interfaces.
Default
Format
no spanning-tree bpdufilter
Mode
spanning-tree bpdufilter default
Use this command to enable BPDU Filter on all the edge port interfaces.
enabled
Global Config
Global Config
disabled
Interface Config
disabled
Interface Config
Default
disabled