Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch プリント

This command displays the VLAN associated with a specific configured MAC address. If no 
MAC address is specified, the VLAN associations of all the configured MAC addresses are 
displayed.

show vlan association mac [<macaddr>]

Double VLAN Commands

This section describes the commands you use to configure double VLAN (DVLAN). Double 
VLAN tagging is a way to pass VLAN traffic from one customer domain to another through a 
Metro Core in a simple and cost effective manner. The additional tag on the traffic helps 
differentiate between customers in the MAN while preserving the VLAN identification of the 
individual customers when they enter their own 802.1Q domain.

This command configures the ether-type for all interfaces. The ether-type may have the 
values of 802.1Q, vMAN, or custom. If the ether-type has a value of custom, the optional 
value of the custom ether type must be set to a value from 0 to 65535.

dvlan-tunnel ethertype {802.1Q | vman | custom} [0-65535]

The IP address assigned to each interface.

The subnet mask.

There is a VLAN Identifier (VID) associated with each VLAN.

Privileged EXEC 

A MAC address for which the switch has forwarding and or filtering information. The 
format is 6 or 8 two-digit hexadecimal numbers that are separated by colons, for example 
01:23:45:67:89:AB. In an IVL system the MAC address will be displayed as 8 bytes.

There is a VLAN Identifier (VID) associated with each VLAN.

vman

Global Config